Orbion The OpenSource Space Mouse
Please note that only Rev2 is taken into consideration
To ensure greater precision and fluidity it is recommended to put a foam ring under the knob (see photo above) and dielectric lubricant in the joystick!
If you notice that your joystick goes in different directions, you can change the direction, swapping the cables VRx and VRy or alternatively the variables horzPin and vertPin in the sketch (Find the joystick section above)
Before printing pay attention to the center distance of the encoder holes, 2 more diffuse sizes are available, 14mm and 17mm (file Enc_holder & Knob_axis)
follow me for other news ?
The ORBION project is OpenSource so if you have the pleasure of supporting my next works I will be grateful fot the coffee.
Cad & 3D sculptors supported (continuously updated):
- Solid EDGE
- Adobe Suite
ATTENTION: It is essential to use ARDUINO PRO MICRO with ATMEL32U4 processor
- M3x15 (3pcs)
- M3x6 or M3x8 (2pcs)
- M3x10 (4pcs)
- Insert 5×4 or 5×5 (Diameter x Height) M3 (9pcs):
- Oled 1.3″ I2C:
- Encoder (KY-040):
- Joystick (KY-023):
https://s.click.aliexpress.com/e/_A8hY9K (important: the joystick shaft must be 4mm)
- Arduino Pro Micro:
- Push Button 8mm: